Komatsu — 15.3 AFTER STORAGE

15. LONG-TERM STORAGE 15.1 BEFORE STORAGE When putting the machine in storage for a long time, do as follows. After every part is washed and dried, house the machine in a dry building. Never leave it outdoors. If the machine must be left outdoors, park it on well-drained concrete and cover it with canvas, etc. Completely fill the fuel tank, lubricate, and change the oil before storage. Apply a thin coat of grease to the metal surface of the hydraulic piston rods. Disconnect the negative terminals of the battery and cover it, or remove it from the machine and store it separately. If the ambient temperature is expected to drop below 0°C, always add antifreeze to the cooling water.

Apply the safety locks to the bucket control lever, lift arm control lever, and directional lever, then apply the parking brake. 15.2 DURING STORAGE WARNING If it is unavoidably necessary to carry out the rust-prevention operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. Operate the engine and move the machine for a short distance once a month so that a new film of oil will be coated over movable parts and component surfaces. At the same time, also charge the battery. Before operating the work equipment, wipe off the grease on the hydraulic piston rod.

If the machine is equipped with an airconditioner, operate it for 3 – 5 minutes once a month to lubricate each portion of its compres- sor. Be sure to idle the engine at low speed for this purpose. Also, check the quantity of refrigerant twice a year. 15.3 AFTER STORAGE NOTICE If the machine is stored without carrying out the monthly rust prevention operation, request your Komatsu distributor for service. Carry out the following procedure when taking the machine out of long-term storage. Wipe off the grease from the hydraulic cylinder rods. Add oil and grease to all places. 2-104