16. TROUBLESHOOTING The towing machine should normally be of the same class as the machine being towed. Check that the towing machine has ample braking power, weight, and rimpull to allow it to control both machine on slopes or on the tow road. When towing a machine downhill, use a larger machine for towing to provide ample rimpull and braking power, or connect another machine to the rear of the machine being towed. In this way it is possible to prevent the machine from losing control and turning over. Towing may be carried out under various differing conditions, so it is impossible to determine beforehand the requirements for towing.
Towing on flat horizontal roads will require the mini- mum rimpull, while towing on slopes or on uneven road sur- faces will require the maximum rimpull. 16.2.1 WHEN ENGINE CAN BE USED If the transmission and steering wheel can be operated, and the engine is running, it is possible to tow the machine out of mud or to move it for a short distance to the edge of the road. The operator should sit on the machine being towed and operate the steering in the direction that the machine is towed. 16.2.2 WHEN ENGINE CANNOT BE USED When towing a machine with the engine stopped, use the following procedure.
If leakage in the air circuit has caused the pressure inside the air tank to drop, the parking brake will be applied. When towing the machine, release the parking brake. 1. The transmission oil does not lubricate the system, so remove the front and rear drive shafts. If necessary, block the tires to prevent the machine from moving. 2. The steering cannot be operated, so remove the steering cylin- der and steering linkage. Even if the brakes are in good condition, the brakes can only be used a limited number of times. There is no change in the operating force for the brake pedal, but the braking force is reduced each time the pedal is depressed. 3. Connect the towing equipment securely.
When carrying out towing operations, use two machines of at least the same class as the machine being towed. Connect one machine each to the front and rear of the machine being towed, then remove the blocks from the tires and tow the machine. 2-107