16. TROUBLESHOOTING 16.2 TOWING THE MACHINE WARNING If the machine that has broken down is towed in the wrong way, it may lead to serious injury or damage. If there is a failure in the brake line, the brakes cannot be used, so be extremely careful when towing. When using the counterweight towing pin for towing opera- tions, tow a load of less than the pin strength of 24 tons. NOTICE Towing is for moving the machine to a place where inspection and maintenance can be carried out, and not for moving it long distances. The machine must not be towed for long distances. For details of the procedure for towing a machine when it has broken down, please contact your Komatsu distributor.
This machine must not be towed except in emergencies. When towing the machine, take the following precautions. When releasing the brakes, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may suddenly move. When towing a machine, tow it at a low speed of less than 2 km/h (1.24 MPH), and for a distance of a few meters to a place where repairs can be carried out. The machine should be towed only in emergencies. If the machine must be moved long distances, use a transporter. Fit a guard plate to the machine being towed to protect the operator if the tow rope or bar should break.
If the steering and brake of the machine being towed cannot be operated, do not let anyone sit on the machine. Check that the tow rope or bar is of ample strength for the weight of the machine being towed. Since the machine being towed may need to travel through mud or up hills, use a tow rope or bar of sufficient strength. Keep the angle of the tow rope as small as possible. Keep the angle between the center lines of the two machines to within 30°. If the machine is moved suddenly, an excessive load will be applied to the tow rope or bar, and it may break. Always move the machine slowly at a fixed speed. 2-106