Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 1. Stop the engine and tighten corrosion resistor valve 1 . 2. When removing radiator cap 2 , lift the lever to relieve the internal pressure. Turn radiator cap 2 slowly to remove it. 3. Prepare a container to catch the coolant, then open drain valve 3 of the radiator and drain plug 4 at the side of the cylinder block and plug 5 on the side of torque converter cooler to drain the coolant. 4. After draining the water, close drain valve 3 , drain plugs 4 and 5 , and fill with city water. 5. When the radiator is full of water, start the engine and run it at low idling.

Open drain valve 3 , drain plugs 4 and 5 , run the engine at low idling, and flush water through the system for 10 minutes. When doing this, adjust the speed of filling and draining the water so that the radiator is always full. While flushing water through the system, watch carefully that the water inlet hose does not come out of the radiator water filler. 6. After flushing, stop the engine, open drain valve 3 , drain plugs 4 and 5 , then close it again after all the water has drained out. 7. After draining the water, clean with a flushing agent. For details of the cleaning method, see the instructions given with the cleaning agent. 8.

After cleaning, open drain valve 3 , drain plugs 4 and 5 to drain all the cooling water, then close them and fill slowly with clean water. 3-27