Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.7 CHECK WINDOW WASHING FLUID LEVEL, ADD FLUID Do this when there is air in the window washing fluid. Check the washing fluid levels in washer tanks 1 and 2 . When the fluid has run short, add automotive window washing fluid. 1 : Front window washing fluid tank 2 : Rear window washing fluid tank To prevent the nozzles from clogging, be careful not to let dust get into the fluid. 24.2.8 CLEAN RADIATOR FINS AND OIL COOLER FINS Radiator fins, oil cooler fins and outer cooler fins. Carry out this procedure if there is any mud or dirt seen stuck to the radiator. 1. Loosen bolt 1 and remove radiator grille 2 . 2.

Use compressed air to clean the mud dust, and leaves from the radiator fins. Steam or water may be used instead of com- pressed air. NOTICE If the steam nozzle is brought too near the radiator fins, the fins may be damaged. Accordingly, keep the nozzle away from the fins. 3. The rubber hose should be checked at the same time. If the hose is found to have cracks or to be hardened by ageing, it should be replaced with a new one. Further, loosen hose clamps should also be tightened. 4. When washing, use nozzle 3 with an opening of diameter ш 2 mm (0.079 in), and keep the water pressure to a maximum of 4 MPa (40 kgf/cm 2 , 568 PSI). 5.

Only when cleaning from oil cooler 4 side, if the mud or dirt cannot be removed, remove fan guard 6 and clean from radiator 5 side or open cover 7 at the side face of the radiator guard and insert the nozzle between the radiator and oil cooler to carry out cleaning. 3-32