24. SERVICE PROCEDURE 8. Clean the filter holder, fill the new filter cartridge with engine oil, then coat the seal and thread of the filter cartridge with engine oil (or coat thinly with grease) and install. 9. When installing, bring the seal surface into contact with the filter holder, then tighten a further 3/4 – 1 turns. 10. After replacing the filter cartridge, add engine oil through oil filler F until the oil level is between the H and L marks on dipstick G . For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 11.
Run the engine at idling for a short time, then stop the engine, and check that the oil level is between the H and L marks on the dipstick. For details, see “24.3 CHECK BEFORE STARTING”. Even if the machine has not been operated for 250 hours, the oil and filter cartridge must be replaced when the machine has been operated for 6 months. In the same way, even if the machine has not been operated for 6 months, the oil and filter cartridge must be replaced when the machine has been operated for 250 hours. Use API category CD class oil. If CC class oil must be used, change the oil and replace the oil filter at half the usual interval (125 hours). 3-58