24. SERVICE PROCEDURE 24.7 EVERY 500 HOURS SERVICE WARNING Be sure to put a warning tag on work equipment control levers 1 . Maintenance for every 50, 100 and 250 hours should be carried out at the same time. 24.7.1 REPLACE FUEL FILTER CARTRIDGE WARNING Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. 1. Open the side panel located on the right of the machine and lock the open lock. 2. Set the container to catch the fuel under the filter cartridge. 3.
Turn fuel stop lever 4 toward you to prevent the fuel from dripping. 4. Remove drain plug P on the bottom of the filter to drain oil. 5. Using a filter wrench, turn filter cartridge 1 counterclockwise to remove it. 6. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 7. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 1/2 to 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel.
If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 8. After replacing filter cartridge 1 , fully open fuel stop lever 4 , then loosen air bleed plug 2 . 9. Loosen feed pump knob 3 and move the pump up and down to draw off fuel until air ceases to come out of air bleed plug 2 . 10. After bleeding air, tighten air bleed plug 2 , then push in the knob of feed pump 3 and tighten it. 3-63