Section C - Electrics Basic System Operation Engine Automatic Warm Up Engine Automatic Warm Up Operation C031610GB-2 Fig 37. This feature allows the engine to quickly warm up to normal operating temperature if the vehicle is not being used. 4 If the throttle volume input changes during auto warm up then the auto warm up function is cancelled. When auto warm is activated the EMS will display the message "AUTO WARM". Automatic warm up will only be performed 15 seconds after the engine is started and provided the following conditions are satisfied:
The ECU1 will send a RPM target message to the ECM so that the engine will run at the throttle dial setting for 5 minutes, the engine revs are then increased in 300 rev/ min. steps in 3 minute intervals up to the maximum of 1800 rev/min. 1 Water temperature is less than 50 єC (engine coolant temperature is sent from the ECM via the CAN bus). 2 Upper pilot pressure switch is off (excavator services not selected) i/p28 (A-6). After 3 minutes of running at 1800 rev/min. the engine revs will return to the throttle dial setting. If during the automatic warm up sequence any of the required conditions change i.e.
engine water temperature reaches 50 єC or the 3 Travel pilot pressure switch is off (travel service not selected) i/p27 (A-16). C-34 C-34 9803/9880-3