JCB — 4.pdf (p.4)

Section C - Electrics Basic System Operation Engine Pre Heat (Glow plugs) Engine Pre Heat (Glow plugs) Operation C049890-2 Fig 35. This feature allows the engine cylinders to be pre-heated, before engine cranking to assist cold start performance. When the key switch is turned to the `Ignition' position the ECM detects the temperature to determine whether and for how long preheat is required. The ignition provides a positive feed to the Preheat relay and an input to the ECM at i/p V24. When preheat is required, the ECM gives a ground to the heat relay coil from o/p V10. The relay energises, which then allows battery voltage to cross the heat relay to the glow plugs.

The ECM sends a `glow signal' message via the CAN bus to the EMS which displays the message "PREHEAT". When the key switch is turned to the `crank' position the ECU1 sends a message via the CAN bus to the ECM to start the engine. C-32 C-32 9803/9880-3