Section C - Electrics Basic System Operation Viscous Fan Viscous Fan ECU 1 EMS A O/p 8 (C-3) FAN DUTY CAN Data B I/p 10 (A-38) C I/p 1 (A-19) D I/p 2 (A-18) 865670 Fig 70. A Viscous fan solenoid B A/C switch 10 20 30 40 50 C C Hydraulic oil temperature 0 60 70 80 90 100 D Engine coolant temperature 100 Operation % Pulley Speed The cooling pack temperature is controlled by an electromagnetically controlled viscous coupling fan. The electromagnetic clutch which drives the fan speed is controlled by a PWM signal from the ECU1. 75 50 Engine water and hydraulic oil temperature are monitored by the ECU1. As their temperatures change, the ECU1 will vary the PWM signal to the electromagnetic clutch.
This changes the speed of the fan. As the temperature increases the PWM signal will decrease to drive the fan faster. If the PWM signal is lost to the electromagnetic clutch the fan will run at full speed. 25 0 10 20 30 40 50 60 70 80 90 100 % PWM Signal 823271 Fig 71. X = Fan Speed +/-50rpm. The output PWM signal will drive the fan RPM to that set by the highest temperature as determined by the graph. K Fig 71. ( T C-74) . Y = Oil Temperature. Z = Water Temperature. C-74 C-74 9803/9880-3 X Y Z