Section C - Electrics Service Procedure Using a Multimeter Using a Multimeter In order to obtain maximum benefit from the fault finding information contained in Section C it is important that the technician fully understands the approach to fault finding and the use of the recommended test equipment, in this case a FLUKE 85 or AVO 2003 digital multimeter, or a moving pointer (analogue) multimeter. The approach is based on a fault finding check list. In tracing the fault from the symptoms displayed you will be directed to make measurements using a multimeter. TC-002 These instructions are intended to cover the use of the recommended multimeters. Fig 8. AVO 2003 Fig 7. FLUKE 85 Fig 9.
A Typical Analogue Meter 1 Make sure that the test leads are plugged into the correct sockets. The black test lead should be C-167 C-167 9803/9880-3