JCB — 77.pdf (p.77)

Section E - Hydraulics Circuit Descriptions Hammer Circuit Hammer Circuit For Schematic, K Fig 21. ( T E-57) The hammer function only works when the hammer pedal 53 is pressed in a forward direction. In this position pilot pressure from the foot pedal closes the hammer pressure switch 45 . The ECM then selects the pre-set hammer RPM on the engine. Pilot pressure from the pedal 53 selects the auxiliary spool via port pa2. The hammer/auxiliary solenoid B remains de-energised in hammer mode allowing pilot pressure to select the hammer/auxiliary changeover valve 27 to select hammer mode. Flow from pump 2 crosses the selected hammer spool and exits the valve block at port A2.

At the changeover valve 27 the pressure to the hammer is regulated by the hammer ARV which is now in circuit via the selected valve 27 . Returning oil is diverted direct to tank via the hammer filter through the changeover valve 27 . Pilot pressure from the hammer pedal 53 is also available to the upper pilot pressure switch 52 . E-56 E-56 9803/9880-3