JCB — 76.pdf (p.76)

Section E - Hydraulics Circuit Descriptions Merged Flow Merged Flow For schematic, K Fig 20. ( T E-55) . This option allows the flow of both pumps to come together where the attachment requires high oil flow. When the merged option is selected, using the rocker switch in the cab and the auxiliary pedal 53 is operated, the hammer/auxiliary switch 45 is closed. Once the pressure switch is closed the ECU1 will energise solenoid A , B and C . Pilot pressure from the pedal will select the auxiliary spool via port pa2 or pb2 depending on the direction selected.

Pilot pressure from the pedal also crosses solenoid B which is now energised and sends a signal to port pcc of the main control valve and selects the merge spool. Solenoid A is selected and allows pressure from the cab manifold to cross and select the merge valve 47 . Solenoid C is selected and allows the spools of the hammer/auxiliary changeover valve 27 to drain to tank and select the auxiliary position. Oil flow from pump 1 is available at the now selected auxiliary spool. Flow from pump 2 is blocked at the merge spool. Pump 2 oil then exits the valve block at P3 . It crosses the selected merge valve 47 , enters the valve block at P4 and merges with oil flow from pump 1.

Both pump flows cross the selected hammer/auxiliary changeover valve 27 to operate the attachment. E-54 E-54 9803/9880-3