Section E - Hydraulics Remote Control Valve (Hand Control) Operation TE-008 The remote control valve is a pressure reduction valve used to control the servo pressure operated system. Four pressure reduction valves used to control the servo pressure are located in the main housing. Direction of the output servo pressure is controlled by selective movement of the control lever. The valves and control levers are mounted in the arm rests on both sides of the operator's seat. springs also provide a resistive force, giving the operator a `tactile feel' of the controls. The control handles contain electrical push button and rocker switches which are used to operate auxiliary services.
The pressure reduction unit is comprised of spools 17 , pressure control springs, return springs and spring seats 13 . The spools 17 are held against the plungers 11 by the return springs 15 . When the control handle is tilted, the plungers 11 move down, depressing the return spring seats 13 , simultaneously compressing the pressure control springs moving the spool, allowing hydraulic oil to flow to the designated pilot port. The lower end of the main body contains the main inlet port P , outlet port T to tank and the servo pressure outlet ports 1 , 2 , 3 and 4 . The servo pressure controls the stroke and direction of the main control valve spools.
This is achieved by providing a spring at one end of the main control valve spools and applying pilot pressure to the opposite end. (In some cases, pilot pressure is applied to both ends of the control valve spool.) Function Oil supplied by the hydraulic servo pump enters at port P and the function of the spools 17 is to direct oil from the inlet port P to the output ports 1 , 2 , 3 and 4 or alternatively, to the exhaust port T to tank. The pressure control springs act on the spools 17 to determine pressure at each port. Plungers 11 slide in the guides to vary the compression in the springs.
The control handle, fixed to the adjusting nut 24 and circular rocker plate 25 is operated to move the plungers 11 . The control handle is able to rotate 360° around the knuckle joint 26 . The return springs operate between the casing and the seats 13 , regardless of the outlet pilot pressure, returning the plungers 11 to their outer positions, ensuring the spools 17 return to their neutral (closed) positions. The E-101 E-101 9803/9880-3