Section E - Hydraulics Hydraulic Rams Dismantling and Assembly Dismantling and Assembly Dismantling the Piston Rod from the Cylinder Tube TE-023 Refer to Section 1, Service Tools. Before starting work, clean all surfaces with a suitable solvent and dry with compressed air. Each part is precision made, so handle with care. Do not force any part as this may cause damage. Protect the dismantled parts if they are to be left for a period of time. 1 Drain the oil. 2 Disconnect the external piping. 3 Secure the ram. Note: Fix the ram in a vertical or horizontal position. The vertical position is more favourable for dismantling/re- assembly work.
Use the bottom pin hole for preventing the ram from turning on its axis and for fixing the ram in the axial position. Remove the cylinder head cap screws (14 off) with an Allen wrench. Use an extension pipe such as shown in the figure below to facilitate bolt loosening. 1.5 m C027430 Fig 62. C027380 Fig 61. E-201 E-201 9803/9880-3