JCB — 36.pdf (p.36)

Section 3 - Maintenance Routine Maintenance Cleaning the Machine Cleaning the Machine 1 Prepare the Machine. K Prepare the Machine for Maintenance ( T 3-29) . Exterior Park the machine on level ground. Open the bucket and swing the boom until it is at 90° to the track. Lower the bucket to the ground. Clean the exterior of the machine using water and/or steam. 2 Raise the Track. If steam is used the machine must be completely greased afterwards. K Greasing ( T 3-36) Pay particular attention to the cab windows. Make sure that the radiator grille is not blocked. Operate the boom and dipper controls so that the track on the side nearest the bucket is lifted up clear of the ground.

Do not allow mud to build up on the tracks and running gear. K Tracks and Running Gear ( T 3-93) 3 Rotate the Track. When it is safe to do so and you are sure that everyone is clear of the machine, operate the controls to rotate the track which is off the ground. Rotate it first one way and then the other to shake off the mud. If necessary, the person outside may use water to get the mud off. Interior !M CAUTION Never use water or steam to clean inside the cab. The use of water or steam could damage the on-board computer and render the machine inoperable. Remove dirt using a brush or damp cloth. 4 Inspect the Track.

8-3-4-8 When you have finished, inspect the track rollers, sprockets and idler wheels for damage and oil leaks. Cleaning the Tracks 5 Lower the Track. !M WARNING Operate the boom and dipper controls to lower the track to the ground. If two people are doing this job make sure that the person operating the controls is a competent operator. If the wrong control lever is moved, or if the controls are moved violently, the other person could be killed or injured. 6 Repeat for the Opposite Track. Swing the boom round to the other side and repeat steps 2 to 5 inclusive for the other track. If you will be working with another person, make sure that you both understand what is to be done.

Learn and use the recognised signalling procedures. Do not rely on shouting - he will not hear you. Cleaning the Radiator and Oil Cooler A clogged radiator and/or oil cooler can lead to engine overheating. Regularly check for a build-up of dirt and debris and if necessary, use compressed air to clean-out the grille. At the same time check all hoses for damage or perishing, and replace if necessary. To clean the tracks, you must turn them. When the tracks are turning, keep clear of rotating parts. Before starting this job, make sure that you have no loose clothing (cuffs, ties etc.) which could get caught in moving parts. Keep people not involved with this job well away!

MD-3-3-2 3-31 3-31 9803/JSM-0412