JCB — 41.pdf (p.41)

Section 3 - Maintenance Routine Maintenance Greasing Greasing Introduction Slew Ring Teeth and Slew Pinion T3-028_2 You must grease the machine regularly to keep it working efficiently. Regular greasing will also lengthen the machine's working life. Refer to the Service Schedule for the correct intervals. Ensure slew ring is kept full of grease. Always grease whenever the machine has been steam-cleaned. For location of the slew ring gear refer to Identification of Machine Components. Note: The machine must always be greased after pressure washing or steam cleaning. 1 Make the machine safe. Stop the engine and remove the starter key. Greasing should be done with a grease gun.

Normally, two strokes of the gun should be sufficient. Stop greasing when fresh grease appears at the joint. Use only the recommended type of grease. Do not mix different types of grease, keep them separate. 2 Grease the Slew Ring. a Remove the inspection port cover A (on the lower centre section). In the following illustrations, the grease points are numbered. Count off the grease points as you grease each one. Refit the dust caps after greasing. b Remove the grease discharge port cover B (on the lower inner side). Note: Where applicable, refer to the manufacturers manual for instructions on the maintenance of optional attachments. c Remove contaminated grease.

d Replace the discharge port cover. e Apply grease to the slew ring via aperture C . !M CAUTION Waxoyl contains turpentine substitute which is flammable. Keep flames away when applying Waxoyl. Waxoyl can take a few weeks to dry completely. Keep flames away during the drying period. Do not weld near the affected area during the drying period. Take the same precautions as for oil to keep Waxoyl off your skin. Do not breathe the fumes. Apply in a well-ventilated area. 5-3-1-9 Slew Ring Bearing There are two grease nipples on the front of the machine and one on the front of the ring. Check that the grease extrudes from under the seal around the entire circumference. Note:

It is not possible to add too much grease. 3-36 3-36 9803/JSM-0412