Section 3 - Maintenance Routine Maintenance Greasing Greasing Points !M WARNING You will be working close into the machine for these jobs. Lower the attachments if possible. Remove starter key and disconnect the battery. This will prevent the engine being started. 8-3-1-3 Table 15. Greasing Points No. Hours A B C D E F G H K J L Fig 8. M 3 Slew the Machine. O N Start the engine and slew the machine a few degrees.Stop the engine, remove the starter key and apply grease again. O Repeat until the whole ring is greased. Check that grease exudes around the entire circumference. R S 4 Refit the inspection port cover. D Fig 9.
3-37 3-37 9803/JSM-0412 om Base 3 1000 om ram, eye end pin 2 50 per ram, dump end pin 1 50 om ram, dump end pin 2 50 cket ram to Bucket linkage 3 50 cket linkage to Bucket pin 1 50 per to Bucket Linkage pin 1 50 per to Bucket pin 1 50 cket ram, dump end pin 1 50 per ram, eye end pin 1 50 om to Dipper, connecting pin 1 1000 B positioning ram, dump end pin 1 50 B positioning ram, eye end pin 1 50 B upper/lower boom pivot pin 115-190 1 50 B upper/lower boom pivot pin 200-360 1 1000 w Ring Teeth 1 500 w Ring Bearing 3 250