Section 3 - Maintenance Routine Maintenance Engine Cooling System 6 Check the radiator is full of coolant to the top of the filler neck. Checking the Coolant Level - 4JJ Engines (Non- Pressurized Expansion Bottle Type) If the level is low: a Switch the ignition ON and switch the cab heater onto hot and full blower speed. 1 Park the machine on solid, level ground. 2 Turn the engine OFF and remove the ignition key. b Top up the radiator with coolant to the top of the filler neck. 3 Let the engine cool down. !M WARNING The cooling system is pressurised when the coolant is hot. When you remove the cap, hot coolant can spray out and burn you.
Make sure that the engine is cool before you work on the cooling system. 9-3-3-1_2 A B Fig 34. D E c Open the EGR cooler plug B to bleed air from the system. d Close the EGR cooler plug. Note: Torque tighten the EGR cooler plug to 25Nm. e Fit the radiator cap. 7 Check the level in the expansion bottle E . K Fig 37. ( T 3-63) . Fig 33. 4 Carefully release the radiator cap A to release system pressure. The level must be at the FULL mark. If the level is low: 5 Remove the radiator cap A . a Top-up the expansion bottle E with coolant. 8 Start the engine. 9 Turn the slew lock ON. 3-59 3-59 9803/JSM-0412