JCB — 49.pdf (p.49)

Section 3 - Maintenance Routine Maintenance Engine Fan Belt Checking the Fan Belt Tension !M WARNING Make sure the engine cannot be started. Disconnect the battery before doing this job. 2-3-3-5 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 2 Check the fan belt tension. There must be 6-8 mm (0.24-0.31 in) slack at X . Fig 46. Fitting a New Fan Belt Complete steps 1 and 2. 1 Loosen the alternator. Slacken bolts A, B and adjust plate C so that the alternator is levered towards the engine, so that the fan belt D can be removed. Fig 45. 2 Fit a new fan belt. Remove the fan belt D and replace it with a new one, make sure the `V' profile locates in the pulleys correctly.

3 Loosen the alternator. Slacken bolts A and B . 4 Adjust the fan belt Note: It may be necessary to apply leverage to the new belt to get it over the pulleys. a Use a lever to re-position the alternator so as to adjust the fan belt tension. 3 Adjust the fan belt. Carry out step 5 of Adjusting the Fan Belt. Note: If the fan belt is stretched so much that it cannot be adjusted correctly, fit a new belt. 4 Re-check the fan belt tension. Check after running the machine for 5 minutes at low idle. b While levering the alternator pinch the bolt A and check the tension on the belt. c If it is not correctly tensioned complete steps 4 and 5.

d When correct tension is achieved fully tighten bolts A and B . 3-71 3-71 9803/JSM-0412