JCB — 57.pdf (p.57)

Section 3 - Maintenance Routine Maintenance Hydraulic System Releasing Tank Pressure Releasing the Hydraulic Pressure !M WARNING Use the procedure below to release the hydraulic pressure. You must release the hydraulic pressure before carrying out maintenance on the machine for example. Do not remove the hydraulic tank filler cap or cover plate when the engine is running. The hydraulic system is under pressure. You or others could be injured. First stop the engine and then release the pressure. 1 Park the machine on hard, level ground and lower the attachment. 8-3-4-4 2 Stop the engine. 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) .

3 Turn the ignition to the 'ON' position. 4 Lower the control lock lever. 2 Release tank pressure. 5 Operate the hand controllers in all directions to release pressure in the hydraulic system. Depress rubber boot A , to release the pressure from the tank. 6 Turn the ignition to the 'OFF' position. . Fig 56. 3-81 3-81 9803/JSM-0412 B A 7 Remove the starter 8 Release the hydr Maintenance, Rel