Section 3 - Maintenance Routine Maintenance Hydraulic System Oil and Filters Topping-up Fluid Level Checking the Fluid Level 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 2 Release tank pressure. K Releasing Tank Pressure ( T 3-81) Position the machine on level ground with the bucket and dipper rams fully extended and the boom lowered to rest the attachment on the ground, as at A . 3 Add Fluid. a Remove plate B . b Refill oil through the filler port using a suitable tundish. c Check the level through the level gauge on the side of the tank. d Refit plate B . Fig 57. 2 Check the level.
Look at the fluid level in the sight tube B . The level should be between the two marks on the tube. If the fluid is cloudy, water or air has entered the system. Water or air in the system could damage the hydraulic pump. Contact your JCB distributor if the fluid is cloudy. 3-82 3-82 9803/JSM-0412