Section 3 - Maintenance Routine Maintenance Hydraulic System Draining Water and Sediment from the Hydraulic Tank Air Bleeding Procedures After replacing the hydraulic oil or repairing or replacing hydraulic components or removing hydraulic pipes, bleed air from the hydraulic circuit 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 2 Release tank pressure, K Releasing Tank Pressure ( T 3-81) . Bleeding Air from the Hydraulic Pump 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 3 Draining the water and sediment. Carefully loosen the drain plug C on the bottom of the tank and drain the sediment and water accumulated at the bottom of the tank.
2 Locate the hydraulic pump, K Machine Description ( T 1-5) . Note: Have a drain pan ready. The task is complete when clean hydraulic oil flows out. 3 Temporarily loosen the hose connection at A to check that oil does not come out of the pump. 4 Seal the system. Tighten the drain plug C . 4 If oil comes out re-tighten the connection, if it does not come out remove the hose and pour hydraulic oil into the pump case through the port. When oil comes out of the port refit the hose connection. 5 Run the machine at idle for five minutes. A Fig 67. JS115-190 3-89 3-89 9803/JSM-0412