Section 3 - Maintenance Routine Maintenance Slew Gearbox Slew Gearbox Checking the Slew Gearbox Oil Level Changing the Slew Gearbox Oil 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 2 Locate the slew gearbox, K Machine Description ( T 1-5) . 2 Drain the oil. a Remove the drain plug, located under the valve block. Allow the oil to drain out. 3 Check the level. a Remove the dipstick A , wipe it clean and re-fit. b Wipe the drain plug clean. Remove any metallic particles. b Remove the dipstick again and check that the oil level is within the min -max range. c Refit the drain plug.
Make sure it is tight. c If necessary, top up through filler port B . 3 Fill with recommended oil through filler port B . K Fluids, Lubricants and Capacities ( T 3-16) . If there is no separate filler port fitted, top up through the dipstick port. 4 Check the level. K Fluids, Lubricants and Capacities ( T 3-16) for oil type. a Remove the dipstick A , wipe it clean and re-fit. 4 Refit the dipstick. b Remove the dipstick again and check that the oil level is within the min-max range. c If necessary, top up through filler port B . K Fluids, Lubricants and Capacities ( T 3-16) for oil type. B A 5 Refit the dipstick. 6 Check for leaks.
Run the machine, operate the slew controls and make sure there are no leaks. Fig 71. 3-92 3-92 9803/JSM-0412