JCB — 62.pdf (p.62)

Section 3 - Maintenance Routine Maintenance Tracks and Running Gear Tracks and Running Gear Tracks !M WARNING When opening the check valve always stand to one side and loosen a little at a time until grease starts to come out. If you over-loosen too much grease could spurt out or the valve cover fly out and cause serious injury. Checking/Adjusting the Track Tension 1 Prepare the Machine. K Prepare the Machine for Maintenance ( T 3-29) . Position the machine on level ground. Run it backwards and forwards several times. Stop after running it forwards.

8-3-4-5 !M WARNING Under no circumstances must the check valve be dismantled or any attempt made to remove the grease nipple from the check valve. Carry out steps 1 to 3 of Cleaning the Tracks . Block up the undercarriage frame. Finish track rotation by running the track forwards. Stop the engine and remove the starter key 8-3-4-9 !M WARNING If a gap C exists between the idler wheel shaft and the track frame, you may use pressure to apply the grease. If there is no gap C after the application of grease, then the necessary repairs must be carried out by your JCB distributor. Raised Machine NEVER position yourself or any part of your body under a raised machine which is not properly supported.

If the machine moves unexpectedly you could become trapped and suffer serious injury or be killed. INT-3-3-7_1 2 Check the Tension. Measure gap A in line with the third roller from the front and between the lower surface of the track frame and the upper surface of the shoe. Table 26. 3 Adjust the Track Tension. Fig 72. Adjustment is made by either injecting or releasing grease from the check valve B . Inject grease to reduce the gap (increase the tension) or open the check valve to release grease and increase the gap. When closing the check valve torque tighten to 60Nm. Note:

Excessive tension can cause the track rail to wear the drive rollers and sprocket, insufficient tension can cause wear to the drive sprocket and track rail. 3-93 3-93 9803/JSM-0412 Machine JS130-JS160 Dimension A (Hard Ground Conditions) 235-255mm JS180-JS260 275-295mm JS290-JS460 340-360mm