JCB — 63.pdf (p.63)

Section 3 - Maintenance Routine Maintenance Tracks and Running Gear Running Gear !M CAUTION Checking the Track Gearbox Oil Level Oil will gush from the hole when the drain plug is removed. Keep to one side when you remove the plug. 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . 2-3-4-2 b Remove filler/level plug A and drain plug B . Allow the oil to drain out. Position the machine on level ground with the level and drain plugs as illustrated K Fig 74. ( T 3-95) . c Wipe the plugs clean. Make sure you remove all metal particles. d Wrap seal tape on the drain plug B and refit. Torque tighten to 37Nm. 3 Fill with new oil for oil type and volume.

K Fluids, Lubricants and Capacities ( T 3-16) . a Pour new oil through filler/level plug A until oil runs out of plug A . b Check the condition of the o-ring, renew if it is damaged. Refit filler/level plug. Torque tighten to 37Nm. 4 Change the oil on the other side. Fig 74. 2 Check the level on one side. Repeat steps 1 to 3 . Clean the area around filler/level plug A and remove it. Oil should be level with plug A . Top up through plug A if necessary for oil types. K Fluids, Lubricants and Capacities ( T 3-16) 5 Check for Leaks. Run the machine, operate the tracking controls and then make sure there are no leaks. 3 Clean and refit the plug. Torque tighten to 37Nm.

4 Check the level on the other side. Repeat steps 1 to 3 . Changing the Track Gearbox Oil 1 Prepare the machine. K Checking the Track Gearbox Oil Level ( T 3-95) 2 Drain the oil on one side. a Place a container below the drain plug to catch the oil. The container must be large enough to hold the maximum gearbox capacity. K Fluids, Lubricants and Capacities ( T 3-16) 3-95 3-95 9803/JSM-0412