JCB — 64.pdf (p.64)

Section 3 - Maintenance Routine Maintenance Bucket Bucket Checking/Adjusting For Side Play 2 Measure the Clearance at C . The clearance should be approximately 0.8 mm K Fig 75. ( T 3-96) . It is possible to compensate for lateral wear which leads to sideways play of the bucket. Regular use of this compensating facility leads to less wear on the bucket swivel pin A and the dipper bushes B . 3 Check the clearance. Fig 75. 1 Prepare the machine. K Prepare the Machine for Maintenance ( T 3-29) . Fig 76. JS03353 Position the machine on level ground. Set the bucket as shown K Fig 76. ( T 3-96) .

Turn it slightly to the left and position it so that the arm end is pressed to the side which is not to be adjusted. Stop the engine, remove the starter key. 3-96 3-96 9803/JSM-0412