JCB — 86.pdf (p.86)

Section B - Body and Framework Service Procedures Cab Structure Cab Structure Direct Glazing Removing the Broken Glass and Old Sealant TB-002_5 The following procedures explain how to correctly remove and install panes of glass that are directly bonded to the cab frame apertures. When carrying out the procedures, relevant safety precautions must be taken. !M WARNING Always wear safety glasses when removing or installing screen glass. Never use a power operated knife when removing the sealant around a toughened glass screen. The action of the knife could cause particles of glass to be thrown with sufficient force to cause serious injury, even when safety glasses are being worn.

Use only hand operated tools when working with toughened glass. 1 Always wear safety glasses during both removal and replacement. 2 Use protective gloves - heavy duty leather gauntlet type gloves when cutting out the broken glass; 'non- slip' type gloves when handling/moving panes of glass; surgical type gloves when using the polyurethane adhesives. BF-2-3_1 1 Position the machine on level ground and apply the park brake. Stop the engine. Put protective covers over the cab seat and control pedestals. 3 Wear protective overalls. 4 Do not smoke - the activators and primers used in the procedures are highly flammable.

2 If a laminated pane breaks it will stay in one piece even though the glass is cracked. A toughened pane will shatter and fall apart. The method of removal of the glass depends upon which type it is. 5 Do not attempt to handle or move panes of glass unless you are using glass lifters. a Laminated glass - leave installed until the old sealant has been cut away, after which it will be possible to lift the broken screen away from its frame housing in one piece. Several special tools are required to successfully complete the removal and replacement procedures. Reference is made to the tools in the text.

The majority of these tools can be obtained locally and the remainder from JCB Service (see Service Tools ). b Toughened glass - remove as much of the shattered glass as possible prior to cutting out the old sealant. The work must only be carried out in a dry, frost free environment. A protective canopy may be required or the machine/frame must be moved to a sheltered area. In damp or wet conditions, hinged doors and window frames can be removed from the machine and taken to a more suitable (dry) environment. 3 Cut out the old sealant, leaving approximately 1 to 2 mm on the cab frame. There are several tools and techniques for doing this: a Pneumatic Knife. K Fig 11. ( T B-27) .

This provides one of the easiest methods of removing the sealant around laminated glass. The tool, powered by compressed air, should be sourced locally. Glass should not be replaced at temperatures below 5°C (41°F). !M WARNING Laminated glass must be handled with extra care to prevent breakage. Wherever possible, store and handle it in a vertical attitude. When placing or lifting the glass in a horizontal attitude it must be supported over its whole area, not just at the edges. BF-1-8_1 B-26 B-26 9803/9880-3