JCB — 93.pdf (p.93)

Section C - Electrics Basic System Operation A.M.S (Advanced Management System) A.M.S (Advanced Management System) Operation TC-011 B The JCB A.M.S system is a whole machine electronic control system. The system controls engine speed, pump power, transmission, excavator functions, lights, wiper, auxiliary circuits, warning lamps, etc. The system is a 'CAN BUS' system which links Electronic Control Units (ECUs) on the vehicle. This stands for 'Controlled Area Network' and uses a special cable in the vehicle harness which consists of two signal wires twisted together covered by a metal foil to prevent any electrical interference. These signal wires form the CAN -BUS.

The CAN - BUS is used to send text and fault codes between the ECUs. The electronic units receive inputs from switches and sensors and drive outputs such as solenoids, lamp bulbs and motors. The outputs of the ECUs are rated to the current requirement of the actuator. C The system comprises of the following main electronic components. 401741-C4 Fig 7. A Electronic Control Unit -1 (ECU-1) 401741-C3 B Electronic Monitoring System (EMS) C Fascia switch panel (FSP). D Engine Control Module (ECM) D A C030670-C3 Fig 6. C-9 C-9 9803/9880-3