7. BFIISNBF130A steering is reversed, correct at the steering BOLTING MOTOR TO TRANSOM box. Motor steering angle is equal when steering wheel is turned full right and full left. If the motor steering angles are not equal: - Major corrections can be made at the steering box (refer to the steering box or steering cable manufacturer’s instructions). - Minor corrections can be made by moving the steeringltilt tube laterally (refer to the BFll5A/BFl30A Shop Manual). Make the steering angles equal as necessary. Apply sealant.
BOLT, 12 x 119 mm (4) The steering cable and/or steering link arm SELF-LOCKING must not come in contact with any part of the 1 1 - BOAT FENDER-WASHER, 12 mm (4) right and full left and at all tilt angles. Correct boat when the steering wheel is turned full NUT, 12 mm (4) PLAIN WASHER, as necessary and check again. 12 mm (8) I Install with rounded I edgelside against painted surface. Apply marine hull sealant to the mounting holes and hardware. Use Hondabond HT (P/N 0871 8-0001) or equivalent silicone sealant for below waterline use. With the motor in place against the transom, verify correct motor height. Motor can be raised by using a lower set of mounting holes.
Attach the motor with marine grade hardware. Use washers under all bolts and nuts. Use additional fender washers against the transom. Use support plates as recommended by the hull manufacturer. Apply a small amount of oil or grease to all bolt threads prior to installation. Be sure at least one thread of the bolt is visible beyond the nut when the fasteners are tightened. I NOTICE I Do not use an air impact tool to tighten or loosen the transom bolts. Using an air impact tool to tighten or loosen the transom bolts can generate enough heat to damage the bolt threads. The air impact tool can also produce enough tightening torque to damage the boat transom. 719 Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co.. Inc.