7. BF115AIBF130A REMOTE CONTROL CABLE INSTALLATION AND ADJUSTMENT SEPARATE COVER FLANGE BOLT, Route and connect cables to the remote control before connecting them to the motor. THROTTLE SHIFT CABLE WIRE HARNES BATTERY CABLE GROMMET viewed from outside HEX. BOLT, 6 x 40 mm edgekide against Dainted surface. BOAT I -E TIE WHITE MARK 1. Pass the main wire harness, indicator wire harness, battery cable and control cables through grommet. Make sure the white mark on the battery cable aligns with the inside edge of the grommet. Position the cable tie on the switch panel wire harness and the indicator wire harness at the inside of the grommet. 4. Install separate cover and tighten bolts securely.
TORQUE: 2. Flange bolt, 6 x 30 mm; 12 N-m (9 ft-lb) Hex bolt, 6 x 40 mm; 10 N*m (7 ft-lb) INDICATOR PANEL WIRE HARNESS MAIN WIRE HARNESS CONTROL CABLE PLATE THROTTLE CABLE \SHIFT CABLE ENGINE WIRE HARNESSES 3. Install the remote control cable plate by aligning groove in control cables and groove in undercase. 5. Connect the indicator panel wire harness and switch panel or main wire harness to the engine wire harnesses. Attach the harness connectors to the holder and secure wire harnesses to harness clip. 711 0 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co.. Inc.