7. BFIlSA/BF130A THROTTLE CABLE CONNECTION 1. Put the remote control lever in the NEUTRAL position. THROTTLE CABLES CLOSE OPEN 4. Move the remote control lever to the full throttle position. Make sure the throttle arm contacts the throttle arm stopper. If the throttle a m does not contract throttle arm stop, check for full stroke at the remote control. Avoid changing the open or close throttle cable adjustment. These cables normally do not require adjustment during predelivery service. If these cables are changed unnecessarily, full 2. Thread the pivot shaft onto the threaded portion of the throttle cable. Apply marine grease to the pivot pin.
Adjust the pivot shaft until it slips into the throttle arm. Install the pivot shaft from the engine side. Install washers on both sides of the arm and secure with a lock pin. 3. throttle and/or idle speed June be adversely affected. If you cannot achieve full throttle or proper idle speed, always check control cable adjustment first before changing the open or close throttle cable adjustment or idle rpm. See Honda Marine BFllSA/BF130A Shop Manual, page 3-10 through 3-13, for cable adjustment. 74 1 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.