honda — BF200A/BF225A

8. BF200NBF225A INSTALLATION HEIGHT RECOMMENDATIONS TRANSOM DRILL FIXTURE Shaft Length Outboard Workable Boat Transom Height Transom Height 635 mm (25 in) (24 - 25 in) 1 XX type 762 mm (30 in) (29 - 3o in) 610 - 635 mm 737 - 762 mm TRANSOM D RI L LI N G Use the upper and lower holes. See also “USING THE TRANSOM MOUNT DRILL FIXTURE” on page 1-23. I Description I P a r t ~ o . I 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 mm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stern bracket.

4 90’ Transom mount drill fixture 07MPZ-ZV301 OC 85 mm (3.35 in) 1. Set the outboard motor onto the boat transom and verify the installation height is correct. 3. Drill four holes using a 17/32 drill bit. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 818