8. BF2OONBF225A STEERING STEERING LINK ARM INSTALLATION SELECTION A single cable steering system is not recommended for either the BF200A or BF225A. The steering system selection is determined by the particular application. Consult the boat manufacturer or steering manufacturer for recommendations. Hydraulic steering would be the best choice to improve boat stability, minimize lost motion in the steering system, and reduce boat chine walk on high-performance boats. Dual cables can also be considered. A good steering system will help to eliminate steering free play which June cause the outboard motor to move side-to-side slightly at high speeds resulting in chine walk.
For further information regarding hydraulic steering or dual cable steering, refer to the hydraulic steering, mechanical steering or dual cable kit manufacturer’s instructions. STEERING PREPARATION BOLT (discard) I (discard) FIBER WASHER &?- (discard) SThNLESS BOLT 1/4-28 (2) NUT (reinstall and tighten) (discard) \ Remove the bolts and bracket from the steering arm. Discard the hardware indicated and reinstall the 1/4-28 bolts. Steering Link Arm P/N 06532-ZY3-UOO (optional part, includes all hardware) CAP rn \ I \ I In1 I \ I I U I 1 Remove the cap from the steeringhlt tube prior to installing the steering system.
Loosely install the hydraulic or mechanical steering cables on the motor before final placement of the motor on the transom. Refer to the steering cable or hydraulic steering manufacturer’s instruction manual for handling procedures. 819 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.