8. BF200NBF225A BOLTING MOTOR TO TRANSOM Pay attention to the washers, support plates (if applicable) and boat transom as the nuts are tightened. This is especially important on boats that are being repowered. If the washers and/or support plates (if applicable) are drawn into the transom material, the transom material is weakened and must be inspected and repaired as necessary before the engine is installed. If the transom is found to be soft, water penetration June have occurred and caused the transom material to rot and weaken. Contact the boat manufacturer for boat repair information as needed.
Make sure the stern bracket sits flat against the boat transom and that there is no trim that would prevent the stern bracket from sitting flat against the boat. If the boat transom has molding that prevents the outboard stern bracket from sitting flat against the transom, contact the boat manufacturer for information on how to remove molding. DUAL MOTOR INSTALLATION Apply zealant. BOLT, 12 x 119 mm (4) FENDER WASHER, SELF n - . NUT, 12 mm (4) \ boat manufacturer)] PLAIN WASHER, 12 mm (8) edgelside against Dainted surface. BOAT I 1. Install the steering system of choice. 2. Install a commercially available tie bar. 3. Adjust the toe-in or toe-out. Refer to page 1-47 for details.
On a dual motor installation when the minimum distance between motors is used, the engine cover of one motor June interfere with the adjacent motor if only one motor is tilted up when the boat is steered full right or full left. pEl Apply marine hull sealant to the mounting holes and hardware. Use Hondabond HT (P/N 08718-0001) or equivalent silicone sealant for below waterline use. With the motor in place against the transom, verify correct motor height. Motor can be raised by using a lower set of mounting holes. Attach the motor with marine grade hardware. Use washers under all bolts and nuts. Use additional fender washers against the transom.
Use support plates as recommended by the hull manufacturer. Apply a small amount of oil or grease to all bolt threads prior to installation. Be sure at least one thread of the bolt is visible beyond the nut when the fasteners are tightened. piGl Do not tilt only one motor up when the boat is steered full right or full left, or the engine cover June be damaged. Do not use an air impact tool to tighten or loosen the transom bolts. Using an air impact tool to tighten or loosen the transom bolts can generate enough heat to damage the bolt threads. The air impact tool can also produce enough tightening torque to damage the boat transom. Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co., Inc. 8 4 I