8. BF200AIBF225A REMOTE CONTROL CABLE INSTALLATION AND ADJUSTMENT REMOTE CONTROL CABLE PLATE Route the electrical harnesses and cables through the boat. Connect the cables to remote control before connecting them to the motor. WHITE TAPE / CABLE FRONT COVER BRACKET 5. Install the remote control cable plate with the 6 x 16 mm hex bolt. 1. Route the battery cable to the front cover bracket. Position the battery cable white tape mark so it aligns with the edge of the front cover bracket. 2. Spray the grommet with silicone spray. REMOTE CONTROL CABLE Viewed from outside REMOTE CONTROL CABLE (Throttle control) INDICATOR PANEL / WATER PRESSURE HOSE [(optional part) puncture rubber BATTERY 3.
Run the fuel hose, indicator wire harness, battery cable and main harness through the undercase grommet A. CABLE membrane] GROMMET A FRONT~OVER I \ BRACKET GROOVE 4. Install the grommet by aligning it with the groove in the front cover bracket. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 811 2