8. BF200NBF225A ENGINE ELECTRICAL UNDERCASE GROMMET A MAIN WIRE HARNESS LOOP 8. Install the control cables with the throttle cable inside and the shift cable outside. Install the clamp (included with engine) on the undercase grommet A or slip a 50 mm (2 in) corrugated flexible hose over the undercase grommet A and secure the corrugated flexible hose (not included) with the clamp. 6. Connect the indicator panel 3 pin and main 14 pin connectors to the engine electrical bracket. Secure the connectors to the locking tabs on the bracket. Route the wires through the locking plastic loop and follow the path to the grommet.
Route the two individual portions of the harness through the grommet as indicated. 7. Loosen the control cable lock nuts approximately 1/2 inch from the end of the cable. Thread the cable ends onto the cables with a minimum of 1/2 inch thread engagement as a starting point for adjustment. Do not tighten the lock nuts at this time. With the remote control lever in the NEUTRAL position, the shorter cable will always be the throttle cable. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 811 3