8. BF200NBF225A SHIFT CABLE CONNECTION 1. Centering remote control lever: a. Move remote control lever to full FORWARD position. b. Slowly return control lever to NEUTRAL position. c. Move control lever to full REVERSE position. d. Slowly return control lever to NEUTRAL position. I CABLE END SHIFT LINK ROD DETENT SPRING\ 3. Apply a light coat of marine grease to the pivot pin and sliding surface. 4. Adjust the cable end until it will just slip over the shift link rod pivot pin. Slide the locking plate forward into the locked position. After attaching the shift cable to the shift link, check for smooth operation by moving the remote control lever to the forward and the reverse positions.
Make sure the shift link moves smoothly and returns to the neutral detent position when the remote control lever is returned to neutral. I NOTICE I GROOVE If the control lever is hard to shift, place a shop towel over the propeller shaft and turn the shaft by hand. Shifting with force will damage the shift mechanism. Once the shift arm moves smoothly and neutral detent aligns, tighten cable lock nut. 2. With the outboard motor in the NEUTRAL position, make sure the detent spring roller is set in the center of the shift arm neutral position groove. If not, move the detent spring LEFT or RIGHT. 8-1 4 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co.. Inc.