honda — BF200A/BF225A

8. BF200NBF225A THROTTLE CABLE CONNECTION 1. Put the remote control lever in the neutral position. THROTTLE ARM THROTTLE ARM STOPPER CABLE END 4. Move the remote control lever to the full throttle position. Make sure the throttle arm contacts the throttle arm stop. If the throttle arm does not contact the throttle arm stop, check for full stroke at the remote control lever. The engine must also return to an ECM controlled idle position when the control lever is returned to the idle position. Tighten the lock nut securely. Avoid changing the open or close throttle cable adjustment. These cables normally do not require adjustment during pre-delivery service.

If these cables are changed unnecessarily, full throttle and/or idle speed June be adversely affected. If you cannot achieve full throttle or proper idle speed, always check control cable adjustment first before changing the open or close throttle cable adjustment or idle rpm. See Honda Marine BF200NBF225A Shop Manual, page 3-18 through 3-21, for cable adjustment. 5. Operate the control lever to check for smooth, proper shift cable and throttle cable operation. 2. Apply a light coat of marine grease to the pivot pin and sliding surface. 3. Adjust the cable end until it will just slip onto the throttle arm. Slide the locking plate forward into the locked position. Date of Issue:

June 2003 0 2001-2003 American Honda Motor Co., Inc. 811 5