AVAILABLE ACCESSORIES Consult the Honda Marine Accessories Catalog (M0045) for current information on gauges, instrument harnesses, wiring harnesses, switch panels, and control boxes. FUEL HOSE CONNECTION BOAT SIDE The fuel hose is 7.5 mm (5/16 in) and the male hose barb is stepped to 12 mm (0.4725 in). The priming bulb hose barbs are 7.5 mm (5/16 in). Make sure the fuel hose is not pinched or crushed as it routes to the boat fuel supply. This could cause an engine malfunction. A water separator is recommended between the boat fuel tank and the motor.
Remove the hose barb from the fuel hose end and connect the fuel hose directly to the water separator outlet 7.5 mm (5/16 in) brass hose barb (not included) and clamp securely. If the outboard motor fuel hose is going to be connected directly into the boat fuel tank supply hose, secure using a fuel hose clamp type as listed above. Secure the hose joint so it does not pound on the boat under deck and become damaged. Do not use unlined, worm-type fuel hose clamps because they will shred the outside of the fuel hose. During operation, check for any fuel or air leaks and repair immediately. If these connections suck air, the engine fuel pump will malfunction.
The primer bulb must be positioned so the outlet end is higher or can be positioned higher than the inlet end. The arrow on the primer bulb must point upward toward the engine. ENGINE SIDE ARROW If you are unable to properly crimp the band type clamp provided, use a good quality stainless steel lined fuel hose clamp. Refer to the Honda Marine Carburetion Manual (TM044) for additional information on fuel hose clamps. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 811 6