honda — Gauges

9. GAUGES INSTALLATION INFORMATION SAFETY INFORMATION Disconnect the battery before starting the installation of any electrical gauge. Use the appropriate size fuse to protect electrical circuits. Be careful to avoid touching wrenches or other tools to the metal frames because short circuits June be caused, resulting in sparks, fire damage or electrical component damage. If electrical wire is added, make sure it is the proper gauge and color for the circuit. SERVICE RULES Before drilling holes for any gauge, verify that there are no wires or other obstructions behind the area that is to be drilled.

Always use masking tape on a fiberglass surface before drilling to minimize possible cracking of the surface. Remove rubber covering from the dash panel before doing any cutting to keep it from tearing. When mounting gauges, do not overtighten nuts. You June crack the gauge housing or the mounting panel. Tighten the nuts until the gauge can no longer be rotated by hand in the dash panel. Before reconnecting the battery and starting the outboard, double check all electrical connections are tight and correct. Make sure that wires are not rubbing on any surface that could cause electrical shorts.

Make sure that wires and wire harnesses are provided with grommets around sharp edges to protect against rubbing. Make sure wires and wire harnesses have the proper amount of slack. Use wire ties or bands to secure wires or wire harnesses to keep them from sagging too much. Always check electrical connectors for proper connection. Make sure rubber covers are properly installed around connectors. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 913