honda — Gauges

9. GAUGES CABLE TIE SPEEDOMETER RUBBER HOSE INSTALLATION ~~ 1. After installing the speedometer in the dash, connect the rubber hose to the back of the speedometer and secure with a cable tie. 2. Route the rubber hose back to the motor alongside the control cables. A slight downward slope from bow to stern will help avoid trapping water. Avoid sharp turns, crimping, kinking, or other forces that June reduce the inside diameter of the hose. Do not coil any excess rubber hose. Carefully measure, then cut to the desired length. RUBBER HOSE 3. Fasten the rubber hose at regular intervals with small plastic wire ties (be careful not to pinch tubing). 4.

Starting at the top of the swivel case, route the rubber hose over the top of the steering arm, down through the inside of the swivel case alongside the shift rod, and out the bottom of the swivel case to the pitot tube. 5. Cut approximately 3 mm (1/8”) off the nipple end. . . RUBBER HOSE Clean the pitot tube if it is clogged with salt or any other foreign material. 6. Cut the hose to the appropriate length to reach the nipple end. CUT ABOUT 3 mm (1/8”) 7. Press the end of the hose over the nipple and secure with a cable tie. 8. Gently feed the pitot tube and rubber hose back up through the swivel case until a slight loop is made in the pitot tube. 9.

Secure the hose to the steering arm with cable ties. 9139 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.