9. GAUGES Speedometer Water Tube Maintenance The pitot tube should be flushed with fresh water before storing the boat for prolonged periods. Any remaining water in the rubber hose should also be removed before storing the boat for prolonged periods. If the pitot tube or rubber hose should become clogged: 1. Disconnect the rubber hose from the speedometer and the pitot tube. 2. Clean the rubber hose with a stiff wire or blow air through it. Do not blow air through the rubber hose when it is connected to the speedometer. High air pressure will damage the speedometer. 3. Flush and clean the pitot tube with fresh water. If necessary, clean the pitot tube opening with a stiff wire. 4.
Reconnect the rubber hose to the speedometer and secure with a new cable tie. 5. Reconnect the rubber hose to the pitot tube nipple end and secure with a new cable tie. WATER PRESSURE GAUGE RUBBER HOSE INSTALLATION 1. After installing the water pressure gauge in the dash, connect the rubber hose to the back of the cable tie. 2. Route the rubber hose back to the motor alongside the control cables. Avoid sharp turns, crimping, kinking, or other forces that June reduce the inside diameter of the hose. Do not coil any excess hose. Cut hose to the desired length. 3. Fasten the rubber hose at regular intervals with small plastic cable ties (be careful to not pinch the hose).
HOSE BF75/90/115/130 1. Remove the grommet and make a hole slightly larger than the rubber hose. 2. Route the rubber hose through the grommet and reinstall the grommet. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 9-40