honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES INSTALLATION POSITION Select the remote control installation position on the boat. 50 mm (1.97 in) minimum LEFT-HAND HANDLE RIGHT-HAND HANDLE SINGLE LEVER TYPE SINGLE LEVER TYPE Both the single and the dual lever type remote controls are available in the right-hand handle type and the left-hand handle type respectively. Select the correct type for the boat. TOP MOUNT INSTALLATION (right-hand handle, single lever type) This section explains the installation procedure of the right-hand handle, single lever type remote control.

The left-hand handle, single lever type remote control and the left-handlright-hand handle, dual lever type remote controls can be installed in the same manner. Do not bend the cables and harnesses sharply. Route the cables1 harnesses with the bending radius of wheel, etc.). K 406 more.

mm (16.0 in) or I Obtain adequate space between the bottom of the remote control and the surrounding parts so that the remote control does not interfere with any of the surrounding parts (steering Install the remote control in the position that allows proper remote control lever operation, and where the cables and harnesses can be routed properly without strain between the remote control and the outboard motor. Recommended Installation Position 138 mm (5.43 in) I 1. Attach the drilling template (included in kit) to the remote control mounting surface using adhesive tape. 2. Drill the installation holes and cut out the center. 3.

Install the control cushion around the opening and spacer (if used). 4. Pass the remote control wire harness and the control cables along the route properly. 5. Remove the cover and the other parts as shown. (2.95 in) (5 in) (6.37 in) The above illustration details the space necessary to install the remote control. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. I 0 4 2