honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES HOUSING LEA I 1 11. Connect the throttle control cable to the throttle arm, in the same manner as the gearshift control cable, with an E-ring. 12. Install the back plate and the housing bracket in the reverse order of removal. /-----7 CONTROL CUSHION- SCREWS BACK PLATE INNER HOUSIN 6. Remove the screws and remove the back plate from the inner housing. 7. Apply marine grease to both the shift and throttle pins at the end of each arm. WASHER WASHER NUT CONTROL CABLE CABLE CLAMP SPACER 8. Install the gearshift control cable groove in the housing clamp groove. Insert the cable end over the pin at the end of the shift arm and secure with an E-ring. 9.

Insert cable clamp spacer in clamp groove. 10. Apply marine grease to the throttle cable pin where it connects to the throttle arm. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 104 3