honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES 6. While holding the stopper bolt, tighten the lock nut. TORQUE: 5-8 N*m ( 3.6-5.8 ft-lb) 7. With the control lever in the full throttle position, recheck at the outboard motor that the throttle arm is against the full throttle stop. THROTTLE FRICTION ADJUSTMENT The operating load of the remote control lever can be adjusted by turning the adjusting screw. Adjust the load according to your preference as described below. Y COVER \ 1. Remove the cover as shown. 2. Adjust the handle operation load by turning the adjusting screw right or left. 3. Use the guide plate (provided with the kit) and install the cover and the housing lead.

Follow the instructions on the guide plate carefully. 104 5 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.