10. CONTROL BOXES AND TEMPLATES WIRE HARNESS CONNECTIONS When using optional harnesses: Check whether wire harnesses are connected as shown on the wiring diagrams on the following pages. Connect leads and terminals securely, and waterproof to prevent moisture from entering and corroding the connector terminals. Observe the following wire harness connector instructions: If the standard 16.5 foot switch panel-to-engine wire harness is too short, please see the Honda Marine Accessories Catalog (M0045) for available harnesses. Maximum combination lengths follow: One or two 7 ft wire harness extensions + one standard 16.5 ft wire harness = max. length 30.5 feet.
One 30 ft wire harness + one or two 7 ft wire harness extensions = maximum length 44 feet. Connect wire harness securely. If a terminal is oxidized or corroded, remove the oxidation or corrosion with a non-conductive plastic scrub pad or contact cleaner before reconnecting it. Make sure insulators completely surround connectors and that ends are not folded up. Do not break the coverings of the wire harness. If the coverings are broken, either repair them with electrician's tape, or replace them. Use vinyl tape to attach any unused terminals to the adjacent main harness to keep them from interfering with surrounding parts. Connect each wire harness properly as shown on the wiring diagram.
After connecting each harness, turn the main power on to check for proper operation. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 104 6