honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES REMOTE CONTROL INSTALLATION After the control cable installation and adjustment, install the remote control. SHIFT CABLE REMOTE CONTROL SPACER PLATE \ \ \ V NUT (3) WASHER (6) 3. Install the shift cable by aligning the cable groove with the cable guide plate. Then connect the eye end to the short arm pin using the washer and 6 mm lock pin. Install the washer on the lock pin side. 1. Put the control lever in the neutral position. 2. Hold the remote control at the desired position, and mark the drill points. Drill three 7 mm (1/4 in) holes at the marked points. 3. Install the control at the selected mounting location (see page 10-21).

Apply one or two drops of Hondalock 2 (PIN 08713-0002) to the threads of the nuts. Tighten the nuts securely. COVER C SCREW(2) . . I CONTROL LEVER FRICTION ADJUSTMENT The control lever friction can be adjusted by turning the friction adjuster at the front of the remote control. ~~, FRICTl0;ADJUSTER \ I THROTTLE CABLE CABLE CLAMP SPACER 4. Install the cable clamp spacer and throttle control cable by aligning the cable groove with the cable guide plate. Then connect the eye end to the throttle arm pin using the washer and 6 mm lock pin. 5. Tighten the lock nuts securely. 6. Install the cover C and tighten the screws securely. TORQUE:

2 N-m (0.2 kg-m, 1.4 ft-lb) I NOTICE I ASE FRICTION DECREASE FRICTION Turning the adjuster clockwise will increase the control lever friction, turning it counterclockwise will decrease the control lever friction. Adjust the friction adjuster so that a slight amount of drag is felt. The remote control lever should move smoothly and freely. Ovettightening the mounting screws can damage or distort the control box. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 10124