honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES 3. Loosen the lock nut and turn the stopper bolt until it touches the throttle lever. The carburetor and control lever must be in the full throttle position. 4. Tighten the lock nut and reinstall the control housing cover C, and 6, and chokelfast idle lever. p7E-l OPERATIONAL CHECKS Before operating the boat, make sure the cables are correctly adjusted and that there are no kinks or sharp bends in the cables. Operate the remote control lever and verify the control cables move smoothly. If the remote control is hard to shift, turn the propeller shaft, Shifting with force will damage the shift mechanism.

Refer to the applicable model-family chapter for motor side cable adjustments. Shift Control Cable Move the remote control lever approximately 30" from neutral or until it just engages forward gear. Verify the click roller at the motor is in the proper groove. Throttle Control Cable 1. Move the control lever to full throttle in the forward gear position. Verify the throttle is actuated and the throttle lever is in the fully- open position. 2. Return the control lever to the NEUTRAL position. Verify the throttle lever moves to the fully-closed position. 3. If not, readjust the throttle control cable eye end at the motor.

The remote control box is designed so when the throttle rod and throttle control cable are adjusted to the standard adjustment setting, the forward full throttle point will be correctly and automatically set. If the full throttle point cannot be obtained, adjust the following: 1. Remove the choke/fast idle lever, control housing cover B and control housing cover C. 2. Move the control lever to full throttle position. STOPPER BOLT .OCK NUT 10-25 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.