10. CONTROL BOXES AND TEMPLATES WIRE HARNESS CONNECTIONS When using optional harnesses: Check whether wire harnesses are connected as shown on the wiring diagram on the following page. Connect leads and terminals securely. If necessary, wrap connections with vinyl tape to waterproof connections. The BF130 requires a 17 wire main wire harness or a 14 wire main wire harness and the 3 wire PGM-FI panel wire harness. If the standard 16.5 foot cable harness is too short, please see the Honda Marine Accessories Catalog (M0045) for additional harnesses and extensions. Observe the following wire harness connector instructions: Maximum combination lengths follow:
One or two 7 ft wire harness extensions + one standard 16.5 ft wire harness = maximum length 30 feet. One 30 ft wire harness + one or two 7 ft wire harness extensions = maximum length 44 feet. Connect wire harness securely. If a terminal is oxidized or corroded, remove the oxidation or corrosion with a non-conductive plastic scrub pad or contact cleaner before reconnecting it. Make sure insulators completely surround connectors and that ends are not folded up. Do not break the coverings of the wire harness. If the coverings are broken, either repair them with electrician’s tape, or replace them.
Use vinyl tape to attach any unused terminals to the adjacent main harness to keep them from interfering with surrounding parts. Connect each wire harness properly as shown on the wiring diagram. After connecting each harness, turn the main power on to check for proper operation. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 10126